BorlandTalk.com

Al Vas · Guest

Hi,

One: Message seems to have been deleted from this newsgroup so am sending
again
Two: Asked this on Steema newsgroups but no answer so thought I might ask
here:

When I set a series % bar width to 100, it displays all the columns fat
except for the last column which displays very skinny. Anything under 100
displays all bars skinny. Ideally I would like to display bars as wide as
possible with a small gap between each (width would be determined by number
of bars on the page ie a page with 10 bars would have wider bars than one
with 30 bars on the page).

Is there any way to achieve this? Is the % bar width not acting as it
should?

Delphi5 Prof/Teechart5.02

Regards

Alex